Bibcode
Castro, Javier; Mack, Brian; Cruz, A.; Gonzalez, Juan C.; Martin, Carlos; Pescador, German; Rodriguez-Ramos, Luis F.; Sanchez, Vicente; Sosa, Nicolas A.; Williams, Mark R.
Referencia bibliográfica
Proc. SPIE Vol. 2199, p. 1141-1153, Advanced Technology Optical Telescopes V, Larry M. Stepp; Ed.
Fecha de publicación:
6
1994
Número de citas
0
Número de citas referidas
0
Descripción
This paper presents a solution to correct wind induced deformation on a
8.0 m thin meniscus mirror supported by a system of astatic active
supports. The correction scheme is based on an active correction using
the force actuators which support the mirror, and a passive rate
dependent coupling of the mirror to the cell. The paper identifies the
fundamental design parameters of the passive correction system and the
active controller, and shows its wind attenuation capabilities. A 3D
simulation verifies the good performance of the system for wind
velocities of about 45 km/h. Furthermore, the influence of cell
deflection on the mirror due to the passive coupling system is shown.